Генератор на 2.8CRD

3 января 2016
3
Возник тут вопрос где находится реле-регулятор. Читаю сервисную книжку и там написано:
The amount of DC current produced by the generator is controlled by EVR circuitry contained within the Powertrain Control Module (PCM). This circuitry is connected in series with the generators second rotor field terminal and its ground.
Voltage is regulated by cycling the ground path to control the strength of the rotor magnetic field. The EVR circuitry monitors system line voltage (B+) and battery temperature (refer to Battery Temperature Sensor for more information).
It then determines a target charging voltage. If sensed battery voltage is 0.5 volts or lower than the target voltage, the PCM grounds the field winding until sensed battery voltage is 0.5 volts above target voltage.
A circuit in the PCM cycles the ground side of the generator field up to 100 times per second (100Hz), but has the capability to ground the field control wire 100% of the time (full field) to achieve the target voltage.
If the charging rate cannot be monitored (limp-in), a duty cycle of 25% is used by the PCM in order to have some generator output. Also refer to Charging Operation for additional information.
Кто сталкивался? Это правда что у нас реле регулятор вынесено в мозги ?
Комментарии
Войдите или зарегистрируйтесь, чтобы оставить комментарий
500 баллов Плюса за отзыв о машине
Поставьте авто в Гараж, подтвердите владение и напишите отзыв
Подробнее